Wacker Neuson BFS 1345 Operator's Manual - Transport To The Worksite
Transport to the worksite
T01111en.fm
16
5.
Transport to the worksite
Requirements:
∗
When transporting the floor saw, use only suitable hoisting gear with a
minimum load-bearing capacity of 150 kg.
∗
Always turn off the motor during transportation!
∗
Empty the water tank!
∗
Remove the cutting blade prior to transport. Set the lowest cutting po-
sition on the floor saw.
∗
Remove the water tank and attach the hoisting gear on the transport
strap (1) for lifting.
∗
If you transport the floor saw on the cargo area of a vehicle, strap it
down securely on the special safety bar.
∗
Fold the guide wheel to the top and the handles to the front (or the stir-
rup handle to the top).
∗
Handles, guide wheel and other operating controls must not be used
as attachment points.
Note: Also observe the regulations in the chapter Safety information.