Wacker Neuson BFS 1345 Operator's Manual - Operation
Manual is about: Floor saw
of
42
T01110en.fm
23
Operation
6.8
Disassembling the cutting blade
Proceed as follows for the disassembly of the cutting blade:
1. Turn off the engine (2) and the water supply (3).
2. Turn the crank (4) in the counterclockwise direction until the blade
is clear of the ground.
3. Fold up the cutting blade guard (1).
4. Loosen the hexagonal bolt. To do this, apply counter pressure on
the spanner surfaces of the cutting shaft.
5. Remove the spring washer and the cutting blade.
6. Fold down the cutting blade guard.
Store the spring washer and the hexagonal bolt in a clean place where
they cannot become dirty. Assemble both parts for the transport of the
machine!