Wacker Neuson EHB 11 BL Operator's Manual - Operation
Other manuals for EHB 11 BL:
Operator's Manual, Operator's Manual
Manual is about: Electric hammer
of
54
34
Operation
EHB 11
7.3.4
Tool holder for tool with spline shaft
Inserting tool
1. Clean tool end.
2. Turn lock bolt by 90°.
3. Push tool into the tool holder as far as it will go.
When inserting a chisel, make sure the notch on the tool points towards the
spline shaft.
4. Turn lock bolt back by 90°.
5. Check to see if the tool is locked by pulling on the tool.
Removing tool
1. Turn lock bolt by 90°.
2. Remove tool from the tool holder.
3. Return lock bolt to original position.
Item
Designation
1
Tool
2
Lock bolt