Wacker Neuson FUE 6 Operator's Manual - Fue 6
FUE 6
Operation
21
7.2
Starting up
Connecting the machine to the power supply
The machine may only be connected to AC single phase, connection values see
chapter Technical Data.
1. Switch off the inverter via the ON/OFF switch.
2. Switch off all connected machines via the respective equipment switch.
3. If required, connect the machine to a permitted extension cable.
Note: See chapter Technical data for the permitted lengths and cross-section
areas of extension cables.
4. Insert the plug into the plug receptacle.
WARNING
A damaged machine part or power cable can result in personal injury caused by
electric current.
f Do not operate a damaged machine!
f Have a damaged machine repaired immediately.
NOTICE
Electrical voltage.
Incorrect voltage can cause damage on the machine.
f Check if the voltage of the current source corresponds with the information
of the machine, see chapter Technical Data.
WARNING
Starting the connected machines.
Danger of injuries from uncontrolled starting of the machines.
f Deactivate all connected machines before connection to the electric power
supply.
WARNING
Electrical voltage.
Injuries from electrocution.
f Check power cable and extension cable for signs of damage.
f Only use extension cables for which grounded conductors are connected to
the plug and the coupling (only for machines of class rating I).