Wadia di122 Owner's Manual - page 14
14
dicate “VOLUME MUTE”. Refer to figure 54. Press-
ing the MUTE Push-button a second time or adjust the
Volume Level to un-mute the di122.
%DODQFH
Listening balance varies with
different program sources, room
acoustics and listening positions
relative to the Loudspeakers. Use
Balance as needed to achieve ap-
proximately equal listening volume
levels in each Loudspeaker. To
adjust the Balance perform the fol-
lowing:
1. Press and release the Push-
button on the Remote Control
to decrease the volume level of
the Right Channel in one decibel
LQFUHPHQWVXSWRG%³%$/-
ANCE, L:0dB R:-30dB” ap-
pears on the Front Panel Display.
Refer to figures 54, 55 and 58.
9ROXPH/HYHO
To change the Volume Level of the Wadia di122, use
WKH9ROXPH'RZQ3XVKEXWWRQRUWKH
9ROXPH8S3XVKEXWWRQRQWKH5HPRWH&RQWUROIRU
the desired listening level. The Volume Level may also
be changed by using the Volume Adjust Mode and the
Front Panel INPUT /
V VOL and STANDBY/ON / U
VOL Push-buttons. To activate Volume Adjust Mode
press and hold in the INPUT /
V VOL Push-button.
The Front Panel Display will now show arrows on ei-
ther side of the current volume setting. Refer to figure
53. Then press the
V VOL or U VOL Push-buttons to
either increase or decrease the Volume to the desired
level. When the arrows disappear from the Front Panel
Display, the Volume Adjust Mode will be deactivated.
Refer to figures 51, 53 and 58.
0XWH
Press the Remote Control MUTE Push-button to
mute the Audio Outputs. Refer to figure 58. When the
Wadia di122 is muted, the Front Panel Display will in-
3RZHU2QDQG2II
The Red LED above the STANDBY/ON Push-button
lights to indicate the di122 is connected to AC Power.
To switch ON the di122, press the STANDBY/ON
Push-button on the Front Panel or the MODE (Power
2Q3XVKEXWWRQRQWKH5HPRWH&RQWURO7KHGL
will go through a brief startup initialization and
with the Front Panel Display indicating the last used
Volume Level Setting. Refer to figures 50, 51, 52 and
58. To switch OFF the di122 press the STANDBY/ON
Push-button on the Front Panel or the MODE (Power
2II3XVKEXWWRQRQWKH5HPRWH&RQWURO
6RXUFH6HOHFWLRQ
Press the INPUT Push-button on the Front Panel or on
the Remote Control to select the desired source. Refer
to figures 51, 52 and 58.
How to Operate the di122
V O L U M E 3 5 %
3 5 2 . 8 k H z
Figure 52
Figure 58
How to Operate the di122
Figure 50
V O L U M E 3 5 %
_ _ _
Figure 53
Å
V O L U M E 3 5 % Æ
D S D 1 2 8
V O L U M E M U T E
3 8 4 k H z
Figure 54
Figure 51
I N P U T : 1 ( C O A X )
_ _ _
Figure 55
B A L A N C E
L : 0 d B R : 0 d B
B A L A N C E
L : 0 d B R : - 3 0 d B
Figure 56