Wagan MINI STEPPER User Manual - page 3
Mini Stepper by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2005 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
ASSEMBLING
*Please refer to the diagram on previous page.
1. Take out the power cable from the LED meter (5).
2. Wire the power cable inside the stand tube (3).
3. Connect the stand tube (3) to the main frame (2) with
bolts.
4. Wire the power cable inside the connecting tube (4).
5. Connect the connecting tube (4) to the stand tube (3)
with bolts.
6. Put the LED meter (5) on the top of the connecting tube
(4) and connect it to the power cable.
7. Connect the two handle bars (6) to the connecting tube
(4) with bolts.
TENSION ADJUSTMENT
1. Locate the screwdriver with the triangular cap called
the tension key (see figure 1)
Figure 1
2. Locate the threaded hole on the opposite side on the stepper
(see figure 2)
Figure 2
3. Screw in the tension key slowly into the threaded hole
4. One side of the stepper will be automatically lifted up as the
tension key gets screwed in deeper into the tube. It might get
harder to screw in once it gets deeper (see figure 3)
Figure 3
Hint: Please, lift up one of the stepper pedals manually and continue
to screw in the tension key
5. Once the tension key has been properly adjusted, please try
the stepper by stepping on both sides
6. If it is properly done, one step will be up and the other will be
down as you do the step exercise and vice versa