Wagan Power Dome EX User Manual - page 6
Power Dome EX
by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
______________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
6.
Connect the Black (-) cable Clamp to a non-moving part on the
vehicle.
7.
Observe the color of the REVERSE POLARITY LED that is
located between the Battery Status and Work Light Switches.
a.
If the LED is RED – DO NOT TURN ON THE
CABLE JUMPER SWITCH
•
Cable Clamps need to be reversed.
•
Disconnect the Black Clamp first and then the
RED Cable Clamp.
•
Reconnect and observe the LED.
b.
If the LED is green, turn
ON
the Jumper Safety Switch.
•
Inside the vehicle, turn on the ignition switch and
attempt to start the engine.
•
Crank a maximum of three seconds. If the engine
does not start, wait three minutes before the next
attempt.
•
After the engine starts, turn
OFF
the Jumper Safety
Switch.
•
Disconnect the Black Clamp first, and then
disconnect the Red Clamp.
8. Be sure that the cables and clamps are securely stored.
9. Recharge the Power Dome as soon as convenient.
NOTE:
If the engine does not start, there may be a problem other than a
discharged battery. Call for service.
WORK LIGHT
The Work Light is a cluster of bright LEDs located above the
negative Jumper Cable storage area.
The location of the Work Light allows the light to be used while the
Power Dome is being carried.
•
Turn the work light switch (on front panel) to
ON
position
•
The light will illuminate.
•
Turn
OFF
while not in use.
EXTENDING RUN TIME
Extending the run time of Power Dome’s inverter, compressor or radio can be
accomplished by powering these functions from a charged external 12 volt
automotive-type battery.
•
Follow the procedure for jumpstarting an engine as far as connecting the
cables checking for correct battery polarity and turning on the Cable
Switch.
•
Now the compressor or inverter can operate for an extended time.
•
The low voltage protection feature will shut off the inverter when the
external and internal batteries discharge to 10 volts.
•
The compressor does not have a low battery shut down feature so the user
must check the Battery Status meter on the Power Dome.
•
After The Power Dome is used in an extended run time configuration,
turn off the compressor or inverter.
•
Turn off the Cable Switch and store the cables and clamps.
•
Recharge the Power Dome and external battery as soon as possible.