WAGNER Cordless Power Roller Owner's Manual - Title
7
English
Title
1. Unplug the power cord. Remove the paint can from the
unit, and place the unit on its side with the Quick-clean ™
adapter facing up.
2. Remove the Quick-clean™ inlet plug from the Quick-
clean™ adapter. Insert a garden hose into the Quick-
clean™ adapter. Turn the Quick-clean™ adapter fitting
counterclockwise to secure the hose. Make sure the
washer stays inside the fitting
(a). Place the unit upright.
3. Hang the roller arm from an empty
five-gallon bucket.
While holding the suction tube over the five-gallon bucket,
SLOWLY turn the garden hose ON. Let the water run
through the suction tube and out the roller arm holes until
the hose runs clear. Empty bucket as necessary.
4. Turn the garden hose off. Remove suction tube from five-
gallon bucket and replace the Quick-clean™ inlet plug.
Leave the arm hanging from the bucket.
5. Plug in the power cord. Flip selector switch to
CLEAN.
Let unit run until all fluids have been purged from the end
of the paint hose. Turn the unit
OFF, and unplug the
power cord. Properly dispose of the cleaning solution.
6. Thoroughly clean the roller cover, core and cap. Press
the quick-release tabs and remove the roller arm from the
handle. Wipe any remaining paint with the appropriate
cleaning solution and a damp cloth
(DO NOT
SUBMERGE ROLLER HANDLE!).
• Follow these steps ONLY if you used latex-based material AND you have an available garden hose.
• Make sure you have completed steps 1-4 in
Cleanup - Purging the Paint Hose
before using the Quick-clean™ feature.
The unit should be placed on its side so material will not
leak from the Quick-clean™ adapter when the plug is
removed. Make sure your floors and furnishings are
protected with a drop cloth.
(a)
Cleanup - Using the Quick-clean™ Feature