WAGNER Paint Crew 770 Owner's manual - Pressure Relief Procedure:
5
English
Always lock the trigger off when attaching the spray tip or when the spray gun is not in use.
Locking the Spray Gun
The gun is secured when the
trigger lock is at a 90º angle
(perpendicular) to the trigger
in either direction.
Unlocking the Spray Gun
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
Locking and Unlocking the Spray Gun:
Pressure Relief Procedure:
O
1. Lock the spray gun off
(see
directions above)
.
Flip the
ON/OFF switch to the OFF position.
3. Unlock the spray gun and trigger
spray gun into the side of the
material bucket. Lock the spray gun.
2. Turn the PRIME/SPRAY knob to
PRIME.
S
P
R
A
Y
P
R
IM
E
Emptying the Hopper:
1. Perform
Pressure Relief Procedure
(see above).
2. Remove the lid from the hopper.
3. Grab top handle of the sprayer with one hand, grab rear handle
with the other.
4. Lift and tilt the sprayer so that material will pour from one of the
front corners of the hopper and into its original container.
The unit, when filled with spraying material, can be heavy.
Make sure to lift with your legs and not your back in order to
reduce the risk of injury.
NOTE - Make sure your floors and furnishings are protected with
drop cloths to avoid property damage.
Before You Begin -
This section contains instructions that
will be repeated throughout this manual.
NOTE - Follow these instructions if the hopper is filled with material and you finish your spraying project without using
all the material in the hopper.
Front
corners
Top
handle
Rear
handle
Be sure to follow the Pressure Relief Procedure when shutting the unit off for any purpose. This procedure is
used to relieve pressure from the spray hose.