WAGNER PAINTCREW Manual - Warning
© 2003 J. Wagner GmbH - All rights reserved.
19
English
L
OCKING AND UNLOCKING THE GUN
Always lock the trigger off when attaching the spray tip or
when the spray gun is not in use.
P
LUGGING IN THE SPRAYER
1. Check that the ON/OFF switch is in the OFF
postion.
2. The connection must be made by correctly
grounded plug socket.
P
RESSURE RELIEF
P
ROCEDURE
Be sure to follow the pressure relief procedure when
shutting the unit off FOR ANY PURPOSE. This procedure is
used to relieve pressure from the spray hose.
1. Lock the spray gun off and
flip the ON/OFF switch to
the OFF position.
2. Turn the PRIME/SPRAY
knob to PRIME.
3. Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4. Lock the spray gun.
WARNING
WARNING
L
OCKING THE GUN
The gun is secured when
the trigger lock is at a 90°
angle (perpendicular) to the
trigger in either direction.
U
NLOCKING THE GUN
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
O
O
SPR
A
Y
PRIME
© 2003 J. Wagner GmbH - All rights reserved.
19
E
MPTYING THE
H
OPPER
1. Perform all the steps of the Pressure Relief Procedure (page 5).
2. Remove the lid from the hopper.
3. Grab top handle of the sprayer with one hand, grab rear
handle with the other.
4. Lift and tilt the sprayer so that material will pour from one of
the front corners of the hopper and into its original container.
P
AINT
S
TRAINING
It is recommended that in order to avoid premature tip and filter
clogging you should strain your paint before spraying. Follow
manufacturer’s recommendations.
C
HOOSING THE
C
ORRECT
S
PRAY
G
UN
F
ILTER
Use the proper gun filter based on the tip size being used.
Tip Size
Paint
Filter
409
For thin materials like
Red filter
40° spray angle/ - Acrylic paints
0,23 mm hole
- Primers
- Stains...
515
For thick materials like
White filter
50° spray angle/ - Internal emulsions
0,38 mm hole
- Latex paints
- Hollow-space sealants...
B
EFORE YOU
B
EGIN
--
T
HIS PAGE CONTAINS INFORMATION THAT WILL BE
REPEATED THROUGHOUT THE MANUAL
.
The spray tip SHOULD NOT be attached until after the
sprayer and spray hose has been purged and primed.
Make sure your floors and
furnishings are protected
with drop cloths to avoid
property damage.
The unit, when filled with
spraying material, can be
heavy. Make sure to lift with
your legs and not your back
in order to reduce the risk
of injury.
CAUTION
WARNING
Front
corners
Top
handle
Rear
handle
O
Follow these instructions if the hopper is filled with material
and 1) your sprayer malfunctions or 2) you finish your
spraying project without using all the material in the hopper.