Summary of ULTIMA PLUS
Page 1
1 ultima plus shaver ultima plus shaver instructions.
Page 2: Contents
2 ultima plus shaver contents general user information page 3 important safeguards page 6 operating instructions page 11 cleaning & maintenance page 13 replacement of parts page 14 troubleshooting page 15 conformity page 17 technical data page 17 wiring page 17 disposal page 17 product registration ...
Page 3: General User Information
3 ultima plus shaver general user information information about using the operation manual ► before using the appliance for the first time, you must read and understand the operation manual completely. ► consider the operation manual as part of the product and store it in a safe and accessible place...
Page 4: Short Introduction
4 ultima plus shaver short introduction 1.After unpacking your shaver, check the product overview and the list of included parts to ensure that your product is complete and that all parts are in good order. 2.Before first use of the product, be sure to read the safety instructions starting on page 6...
Page 5: Note:
5 ultima plus shaver note: check that all accessories are included and undamaged. 1.Protective cap 2.Blade head 3.On / off switch with travel lock 4.Charge display 5.Connection for power cable 6.Long hair trimmer 7.Cutting system with double shaving foil and integrated long hair trimmer 8.2-in-1 pro...
Page 6: Important Safeguards
6 ultima plus shaver please retain this leaflet for future reference. Read all instructions before using. Important safeguards when using this electrical appliance, especially when children are present, basic safety precautions should always be observed including the following. Danger for children ►...
Page 7: Symbols On The Shaver
7 ultima plus shaver ► do not use the device to cut artificial hair or animal hair ► children must not play with packaging material. Do not allow children to play with plastic bags. Danger of suffocation. Symbols on the shaver the hand-held shaver can be rinsed under running water. Danger! Disconnec...
Page 8: To Appliance
8 ultima plus shaver again, but have it checked by a specialist. ► if the device is used in a bathroom, the cord connecting the device to the mains power must be pulled out after use, as the proximity of water represents a hazard, even when the device is switched off. ► installation of a residual cu...
Page 9: Batteries
9 ultima plus shaver ► always pull at the charger and never pull on the cable when unplugging the charger. ► remove the charger from the power point: 1. After each use 2. After each charging process 3. If a fault occurs 4. Before connecting the device to the cable 5. Before cleaning the shaver ► to ...
Page 10: Warning! Risk of Injury
10 ultima plus shaver mouth, nose and skin. Rinse immediately with plenty of clean water and consult a doctor. The electrolyte solution can cause irritation. Warning! Risk of injury ► place the cable in such a way that no one trips over it or steps on. ► do not use the device on open wounds, cuts, s...
Page 11: Operating Instructions
11 ultima plus shaver operating instructions charging •before first operation of the shaver in battery mode, you should recharge the shaver for at least 60 minutes. •in order to maximise the battery life, you should allow the batteries to completely discharge before recharging them. •the shaver runs...
Page 12: Shave
12 ultima plus shaver the shaver can still be used whilst being charged. 1.Please ensure the shaver is switched off before plugging into the mains power supply. 2.Connect the charger to the shaver. 3.Plug the charger into an easily accessible power point. 4.Take off the protective cap. 5.Use the on ...
Page 13: Cleaning And Maintenance
13 ultima plus shaver three- / five-day beard shaver • you can use the long hair trimmer (6) and the trimmer cap (8) to shave a three or five day beard. Click the trimmer cap (8) onto the blade head (2). • slide the long hair trimmer (6) into the desired position. A)position 1 will produce a beard l...
Page 14: Wet Cleaning
14 ultima plus shaver wet cleaning •shaving head and cutting blades can be cleaned under warm, running water (max 70 °c) wet cleaning with “lift & wash” function: •press the release buttons (11). The blade head frame will automatically slide into “lift &wash” position (7). •hold the shaver head unde...
Page 15: Troubleshooting
15 ultima plus shaver 3.Grasp the old cutting blades at both ends between thumb and index finger and pull them carefully off the shaver. 4.Take the new cutting blades at both ends between thumb and index finger and push them into the white holding device. Press the cutting blades completely and brie...
Page 16: Conformity
16 ultima plus shaver conformity the ce mark was applied in accordance with the corresponding european directives. Technical data in the interest of product improvements, we reserve the right to make technical and optical changes to the device and accessories. Article no. Please check the following ...
Page 17: Wiring
17 ultima plus shaver wiring warning: if the transformer is damaged it must be replaced. This product must only be used with the transformer supplied, should a replacement be required contact wahl customer services. Disposal handle with care! Environmental damage in the case of incor- rect disposal....
Page 18: Product Registration
18 ultima plus shaver product registration wahl are constantly developing and launching new products in the uk. We would like to understand your product needs and expectations and we value any comments you may have. As part of wahl customer services, we are offering you the chance to be kept up to d...
Page 19: Guarantee
19 ultima plus shaver guarantee this product is guaranteed against defects in material and workmanship for a period of 3 years from the date of original purchase or receipt as a gift. Should this product become defective during the guarantee period, return it to the store of purchase together with y...
Page 20
20 ultima plus shaver wahl (uk) limited herne bay trade park sea street herne bay kent ct6 8jz. Customer services t : 01227 740066 www.Wahl.Co.Uk form no. Zb451 rev0 10-14 sap no.: 129772-00