Wahl ULTIMA PLUS Instructions Manual - Operating Instructions
11
ULTIMA PLUS SHAVER
OPERATING INSTRUCTIONS
CHARGING
•Before first operation of the shaver in battery mode, you
should recharge the shaver for at least 60 minutes.
•In order to maximise the battery life, you should allow the
batteries to completely discharge before recharging them.
•The shaver runs on 2 NiMH high performance batteries with
protection against overcharging. The batteries can be recharged
without a risk of overcharging or lowering performance.
•Please note that the battery life will decrease during extended
periods of storage. For this reason, long recharging times
should be avoided because of the interruption between the
charging and discharging cycles.
1.Place the shaver on a level surface.
2.Connect the charger to the shaver.
3.Insert the charger into an easily accessible power point.
4.Recharging status is indicated by a green LED that lights up
in the recharging display (4).
5.After charging for about 60 minutes, the batteries will be fully
charged. This is indicated by a green flashing LED..
6.Once the batteries are fully charged, the shaver can be used
in battery mode for about 45 minutes.
7.Unplug the power cable from the power point and from the
shaver as soon as the batteries are fully recharged.
8.The shaver can also be recharged using the “quick recharge”
process that takes about 3 minutes. This status is indicated
by the green LED in the recharging display (4). This charge
is sufficient for a single shave.
9.If your shaver stops during shaving due to its batteries
being insufficiently charged, you can continue shaving by
connecting it to a power point.
OPERATION
WARNING. Do not operate the shaver if the shaving foil is
damaged.