Waist King FOOD WASTE DISPOSER Owner's Manual - page 3
2. DISHWASHER CONNECTION
If you are utilizing a dishwasher, complete the follow-
ing procedure. If dishwasher is not to be connected
go on to section 3.
A.
Using a blunt instrument (steel punch or wooden
dowel), knock out entire plug (see 2A). Do not
use a screwdriver or sharp instrument. When
knockout plug falls into disposer, you may
remove it or simply grind it up when the disposer
is used. This will not damage the disposer in any
way, but may take some time to grind, over the
course of several uses. Go to Section 3.
B.
Connect dishwasher hose using hose clamp. If
hose size is different, you will need a Dishwasher
Connector Kit (see 2B). Make sure all plumbing
connections are tight and in accordance with all
plumbing codes and ordinances. Run water and
check for leaks.
KNOCK
OUT PLUG
2B
DISHWASHER
HOSE
RUBBER
HOSE
*
AIR GAP
DISPOSER
*Air gap may not be required
for all installations. Check local
plumbing codes.
3. INSTALLATION OF MOUNTING ASSEMBLY
YOUR DISPOSER COMES WITH ONE OF THE FOLLOWING MOUNT SYSTEMS
Proceed to the instructions for your type of mount system.
3-Bolt Mount System
EZ Mount System
SINK FLANGE
SINK FLANGE GASKET
PROTECTOR RING
FIBER GASKET
SINK MOUNT RING
MOUNTING SCREWS (3)
SUPPORT RING
MOUNT RING
TIGHTENING EARS
CUSHION MOUNT
SINK FLANGE*
SINK FLANGE GASKET
* An extended sink flange (Item # 3140) is
available for deep-well, cast iron sinks. (For
3-bolt mount only.)
2A
NOTE: Pay close attention to the order of mount
assembly parts, as they have been correctly assembled
by the factory. (See 3A and 3B.)
A.
Disassemble the mounting assembly, as it has
been shipped, by turning the sink flange until the
projections align with the notches in the mount
ring and allow you to pull the sink flange up and
out of the remaining mount assembly. Note the
sequence of these parts as they are stacked and
refer to 3A and 3B to identify each part. Unpack
the 3 mount screws and screw them half way
through the mount ring (notice “THIS SIDE UP”
is imprinted on top of the mount ring).
Next, stack the rubber gasket on top of the pro-
tector ring and sit them on top of the pointed
ends of the mount screws.
B.
Keep these assembled parts together and set aside.
Before you connect the disposer to the mount
assembly under the sink, you may want to prac-
tice engaging the groove of the Hush Cushion®
to the ridge at the bottom of the sink flange (see
3A and read Sec. 6).
C.
Be sure your sink is clean. Pack the underside rim
of the sink flange with plumber’s putty (see 3C).
Position the sink flange so it is centered and read-
able as you look into your sink. Push the sink
3-Bolt Mount System
READ COMPLETELY BEFORE STARTING