Waldorf RN8200E Installation And Operation Manual - page 12
10
Installation Requirements
NOTE:
• It is most important that this Electric Cooktop is installed correctly and that operation is
correct before use. Installation shall comply with local electrical and health and safety
requirements.
• This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.
Waldorf Cooktops are designed to provide years of satisfactory service, and correct installation is essential
to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering gas and fire safety.
Australia / New Zealand
AS / NZS3000
- Wiring Rules.
United Kingdom:
BS 7671
- Requirements for Electrical Installations.
Installations must be carried out by qualified persons only. Failure to install equipment to the
relevant codes and manufacturer’s specifications shown in this section will void the
warranty.
Unpacking
• Remove all packaging and transit protection from the appliance including all protective plastic
coating from the exterior stainless steel panels.
• Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
• Report any deficiencies to the distributor who supplied the appliance.
• Check that the available electrical supply is correct to that shown on the Rating Plate attached to the
underside of the R/H side, front Cooktop lower trim, for Bench, Cabinet Base and Leg Stand Models.
For the Refrigerated Base Models the rating Plate is located inside the right hand front panel and can
be viewed through the upper grille.
Location
1.
Installation must include adequate clearance and ventilation.
2.
Position the appliance in its approximate working position.
3.
The legs must always be fitted. Ensure that the legs are securely attached.
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Installation
Combustible Surface
Non Combustible Surface
Left / Right Hand Side
250mm
0mm
Rear
50mm
0mm