- DL manuals
- Waldorf
- Ranges
- RN8410G
- Installation And Operation Manual
Waldorf RN8410G Installation And Operation Manual
Summary of RN8410G
Page 1
I n s t a l l a t i o n a n d o p e r a t i o n m a n u a l rn8410g rn8820g gas range static oven date purchased serial number dealer service provider 228689-18 rnl8410g rnl8820g for use in gb, ie & dk.
Page 2
The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the manufacturer. In line with policy to continually develop and improve its products, moffat ltd. Reserves the right to change the specifications and desig...
Page 3
1 waldorf gas static oven range rn(l)8410g gas range static oven - 600 mm. Rn(l)8820g gas range double static oven - 1200 mm. Introduction .............................................................................................. 2 specification .....................................................
Page 4
2 introduction we are confident that you will be delighted with your waldorf gas range static oven and it will become a most valued appliance in your commercial kitchen. To ensure you receive the utmost benefit from your new waldorf appliance, there are two important things you can do. Firstly: plea...
Page 5
3 specifications model numbers covered in this specification rn[1]8410g [2] gas range static oven + 4 open burners. Rn[1]8413g [2] gas range static oven + 2 open burners + 300 mm griddle. Rn[1]8416g [2] gas range static oven + 600 mm griddle. Rn[1]8820g [2] gas range double static oven + 8 open burn...
Page 6
4 specifications gas supply requirements - non ce only (australia / new zealand): - ce only: appliance classification category: ii 2h3p (20, 30 / 37). Flue type: a 1. * the burner operating pressure is to be measured at the manifold test point with two burners operating at full setting. The operatin...
Page 7
5 dimensions rn(l)8410g rn(l)8410g rn(l)8413g rn(l)8416g gas cooktop options.
Page 8
6 dimensions rn(l)8820g rn(l)8820g rn(l)8823g rn(l)8826g rn(l)8829g gas cooktop options.
Page 9
7 installation requirements note: • it is most important that this appliance is installed correctly and that operation is correct before use. Installation shall comply with local gas and health and safety requirements. • this appliance shall be installed with sufficient ventilation to prevent the oc...
Page 10
8 clearances note: only non-combustible materials can be used in close proximity to this appliance. * side clearances can be 50 mm when the adjacent surface is at least 100 mm below the cooking surface. Assembly note: • all models are delivered completely assembled. No further assembly is required. ...
Page 11
9 note: the gas pressure regulator provided with this appliance is convertible between natural gas and lpg as per the ‘gas conversion section’ in this manual. Ensure the regulator is converted to the correct gas type that the appliance will operate on. The regulator outlet pressure is fixed ex-facto...
Page 12
10 operation guide 1. Waldorf appliances have been designed to provide simplicity of operation and 100% safety protection. 2. Improper operation is therefore almost impossible, however bad operation practices can reduce the life of the appliance and produce a poor quality product. To use this applia...
Page 13
11 open burners note: only cooking pans from size Ø 150 mm to Ø 420 mm are suitable fo use on these open burners. Flame failure option (f-models) lighting the open burners flame failure protection is incorporated for each burner by way of a thermo-electric system which will shut off the gas supply t...
Page 14
12 griddle these griddles are fitted with a pilot as a standard option and flame failure protection, which is incorporated by way of a thermo-electric system for each main burner. Flame failure protection will shut off the gas supply to that burner in the event that the pilot for that burner goes ou...
Page 15
13 oven pilot ignition 1. Open the oven door. Depress the thermostat control knob and rotate anti-clockwise to the ‘pilot’ position. 2. With the gas control knob depressed, press the piezo ignition button to ignite the pilot burner. Repeat items 1 to 2 until the pilot is lit. 3. Release the gas cont...
Page 16
14 general clean the range regularly. A clean range looks better, will last longer and will perform better. Carbonised grease on the surface or between the trivets, griddle plates will hinder the transfer of heat from the cooking surface to the food. This will result in loss of cooking efficiency. N...
Page 17
15 daily cleaning 1. The grease / spill trays should be checked and emptied frequently to prevent overflow and spillage. Remove the grease drawer while still warm so that the grease is in a liquid state. Empty any grease from the drawer and wash thoroughly in the same manner as any cooking utensil. ...
Page 18
16 trivets and burners a. Remove the trivets from the top of the appliance, taking note that the trivets are manufactured with a lip on one edge, the lip must always be fitted to the outer edge (front and back) of the range. (see fig 10). B. Remove the burner cap and burner bowl (these are a loose f...
Page 19
17 note: it is imperative that the trivet supports are correctly re-fitted to the unit to ensure that the trivets locate correctly and sit flush and level. Note that the trivet support front end side rail profiles are different at either side (refer to fig 6) and only one of the side rails seat into...
Page 20
18 fault finding this section provides an easy reference guide to the more common problems that may occur during the operation of your appliance. The fault finding guide in this section is intended to help you correct, or at least accurately diagnose problems with your equipment. Although this secti...
Page 21
19 conversion procedure note: • these conversions should only be carried out by qualified persons. All connections must be checked for leaks before re-commissioning the appliance. • for all relevant gas specifications refer to the table at the end of this section. Open burners ('f' - flame failure o...
Page 22
20 gas conversion and specifications 12. Refit all the trivet supports to the top of the appliance. Note the orientation of the trivet support when re-fitting. The trivet support front end side rail profiles are different from the rear end side rail profiles. (see fig 14). 13. Refit the trivets to t...
Page 23
21 pilot injectors a. Unscrew and remove the pilot injector plug from the fitting at the end of the pilot injector tube using a 11 mm a/f spanner. (see fig 23). B. Using a flat bladed screwdriver, unscrew and remove the pilot injector from the pilot injector housing. Note take care not to lose the s...
Page 24
22 griddle pilot burner a. With the gas supply turned off at the main supply, remove the griddle plate section by lifting it straight off the cook top. B. Remove the gas control heat shield from around the griddle burner, this is just a push in fit. C. Disconnect the thermocouple and the piezo ignit...
Page 25
23 oven main injector: a. With the gas supply turned off at the main supply, unscrew and remove the 6 screws securing the lower lintel to the front of the oven. (see fig 31). B. Remove the lintel from the oven. C. Open the oven door and remove the cast oven sole plate from inside the oven. D. Remove...
Page 26
24 gas conversion and specifications note, pin rotated for lpg gas regulator note: the regulator supplied is convertible between natural gas and lpg, but it’s outlet pressure is fixed ex-factory and is not to be adjusted. 1. Ensure that the gas supply is turned ‘off’ at the mains. 2. Unscrew the hex...
Page 27
25 gas specifications - non ce only (australia / new zealand): - ce only appliance classification category: ii 2h3p (20, 30 / 37). Flue type: a 1. * the burner operating pressure is to be measured at the manifold test point with two burners operating at the ‘high’ setting. The operating pressure is ...
Page 28
26 replacement parts list when ordering replacement parts, please quote the part number and the description as listed below. If the part required is not listed below, request the part by description and quote model number and serial number which is shown on the rating plate. Cook top open burners 22...
Page 29
27 oven 022446 oven burner. 018691k oven pilot burner kit. 018682 oven thermocouple (1500 mm). 018743 thermocouple spacer. 018744 electrode. 019407 ht cable. 032240 oven burner injector (nat gas) Ø 2.40 mm. 032140 oven burner injector (lpg) Ø 1.40 mm. 026488 pilot injector (nat. Gas) 0.35. 019217 pi...
Page 30
28.
Page 31
29.