Waldorf RN8510G Installation And Operation Manual - page 26
24
Gas Conversion and Specifications
Gas Specifications
- Australia:
- New Zealand:
- (*) Measure burner operating pressure at manifold test point with two burners operating at full setting.
Operating pressure is ex-factory set, through the appliance regulator and is not to be adjusted, apart from
when carrying out Gas Conversion, if required. (Refer to information in this section for details).
Natural Gas
LP Gas (Propane)
Open Burner
Main Burner Injectors
Ø 2.45mm
Ø 1.50mm
Pilot Burner ('PF' Option Only)
0.30 0.20
Griddle
Main Burner
Ø 2.10mm
Ø 1.30mm
Pilot Burner
0.35 0.23
Main Burner
Ø 2.60mm
Ø 1.60mm
Pilot Burner
0.35 0.23
Supply Pressure
1.13 - 3.40 kPa
2.75 - 4.50 kPa
Burner Operating Pressure (*)
0.95 kPa
2.6 kPa
Gas Regulator Cap Screw
Oven
Burner Aeration Setting
Fully Open
Fully Open
Burner Aeration Setting
Fully Open
Fully Open
Low Fire
Ø 1.5mm
Ø 0.95mm
Natural Gas
LP Gas
Open Burner
Main Burner Injectors
Ø 2.45mm
Ø 1.50mm
Pilot Burner ('PF' Option Only)
0.30 0.20
Griddle
Main Burner
Ø 2.10mm
Ø 1.30mm
Pilot Burner
0.35 0.23
Main Burner
Ø 2.60mm
Ø 1.60mm
Pilot Burner
0.35 0.23
Supply Pressure
1.13 - 3.40 kPa
2.75 - 4.50 kPa
Burner Operating Pressure (*)
0.95 kPa
2.6 kPa
Gas Regulator Cap Screw
Oven
Burner Aeration Setting
Fully Open
Fully Open
Burner Aeration Setting
Fully Open
Fully Open
Low Fire
Ø 1.5mm
Ø 0.95mm