Waldorf RN8510G Installation And Operation Manual - page 24

22 

Gas Conversion and Specifications

12.  Refit all the trivet supports to the top of the appliance.  Note 

the orientation of the trivet support when re-fitting as the 

front end side rail profiles are different from the rear end side 

rail profiles.  (See Fig 14). 

13.  Refit the trivets to the top of the appliance taking note that 

the trivets are manufactured with a lip on one edge, the lip 

must always be fitted to the outer edge (front and back) of 

the cook top.  (See Fig 18). 

Low Fire Adjustment 

a.  To adjust the open burner low fire adjustment, remove the 

gas control knobs from the front of the control panel. 

b.  Adjust the low fire adjustment screw on the open burner 

gas control valves to obtain the desired flame size.  

(See 

Fig 19).

NOTE:  The “Low Fire Screw” should be sealed with coloured 

paint on completion of the low fire adjustment. 

Open Burners ('PF' - Pilot & Flame Failure Option) 

1. 

Turn ‘OFF’ the gas supply at the main supply. 

2. 

Remove the trivets from the top of the appliance, taking note 

that the trivets are manufactured with a lip on one edge, the 

lip must always be fitted to the outer edge (front and back) of 

the cook top.  (Refer to Fig 18). 

3. 

Remove the burner caps and burner bowls (these are a loose 

fit to the manifold) from the top of the gas manifold. 

4. 

Remove all the trivet supports from the top of the appliance.  

Note the orientation of the trivet supports when removing.  

The trivet support front end side rail profiles are different from 

the rear end side rail profiles.  (Refer to Fig 14). 

5. 

Remove the pilot burner shields from over the pilot burners / 

thermocouples by removing the 2 screws securing the pilot 

burner shields to the splash guards.  (Refer to Fig 21). 

6. 

Remove the splash guards covering the burner manifolds by 

unscrewing the two allan headed screws.  Carefully remove 

the splash guards taking care not to damage the pilot burner 

tubes and thermocouples protruding through the splash 

guard. 

Main Injectors 

a.  Unscrew and remove the main injectors (½ A/F) from the 

gas cocks.  

(See Fig 22).

b.  Replace with the correct size injectors.  Refer to the ‘Gas 

Specifications table’ at the end of this section and the 

Rating Plate attached to the underside of the right hand 

side, front oven lower trim for correct injector sizes for the 

corresponding gas. 

Fig 9 

Notice Lip on 

Trivet Edge 

Fig 18 

Low Fire Adjustment Screw 

Fig 19 

2 Pilot Burner 

Shield Screws 

Main Injector 

Pilot Injector 

Plug 

Fig 20 

Fig 21 

Fig 22 

Pilot Burner 

Shield