Waldorf RN8510G Installation And Operation Manual - page 27
25
Gas Conversion and Specifications
Oven
Injector:
a. With the gas supply turned off at the main supply,
unscrew and remove the 6 screws securing the
lower lintel to the front of the oven.
(See Fig 30).
b. Open the oven door and remove the cast oven sole
plate from inside the oven.
c. Remove the 2 screws securing the oven burner in
the oven and remove the main burner from the
oven.
d. The main injector will now be exposed and can be
unscrewed and removed using a 13 mm (
1/
2
” A/F)
spanner.
(See Fig 31).
e. Remove the main injector and replace with the
correct size injector. (Refer to the ‘Gas
Specifications’ table at the rear of this section).
f. Refit the main burner to the oven and secure in
position with the 2 screws.
Pilot:
a. To remove the oven pilot injector, from inside the
oven, unscrew and remove the thermocouple and
piezo igniter from the mounting bracket.
(See Fig
32).
b. Unscrew the hex nut holding the pilot supply tube
to the rear of the pilot assembly.
c. Withdraw the pilot injector from the pilot
assembly.
d. Replace the pilot injector with the correct sized
injector for the gas type being used and
re-connect the pilot supply tube to the pilot
assembly.
(See Fig 32).
e. Refit the vitreous enamelled tray to the oven.
Low Fire:
a. To change the thermostat ‘Low Fire’ screw for the
gas type required, remove the gas control knob
from the oven control panel. The gas control knob
is a push fit onto the shaft of the oven gas control
valve. Remove the gas control knob.
b. Unscrew the single screw at the top of the oven
control panel, securing the panel and lift the panel
away from the oven.
c. Unscrew and remove the old ‘Low Fire’ screw
(See
Fig 33)
from the lower left hand front of the valve
and fully screw in the new ‘Low Fire’ screw for the
new gas type. (Refer to the ‘Gas Specifications’
table at the rear of this section for screw types).
d. Close the control panel and secure with the
securing screw.
e. Refit the oven gas control knob to the spindle of
the oven gas control valve.
6 screws
Shown with door removed for ease of viewing
Fig 30
Main Injector
Fig 31
Pilot Supply Line
Thermocouple
Piezo Igniter
Pilot Assembly
Fig 32
Low Fire
Screw
Fig 33