Walimex Daylight 150 Instruction Manual - page 7
13
5.
Clean the device if necessary.
See Cleaning.
6.
Demount standard reflector. See Mount/demount standard reflector
7.
Put the device and all demounted elements in one carton and carry and
store them according to the requirements in the technical
specifications. See Technical specifications.
9.
Solve problems
Problem
Possible reason
Remedy
Device is
switched on,
but has no
function
Power cord is not plugged or
plugged incorrect
Plug in the power
cord correctly
Lamp do not
light up
Lamp is switched off
Switch lamp on, see
Screw lamp in and out
Problem
Lamp is not screwed in firmly
Screw the lamp more
firmly into the socket
Lamp is defect
Change lamp, see
Screw lamp in and out
Possible reason
Remedy
14
10.
Maintenance
10.1
Continuous inspections
What you should do?
Before
every
operation
With every
change
Check all cables and plugs for damages
In case of damage:
WARNING! Danger of electric shock and
fire through short-circuit. The device should
be repaired by an electrician immediately
X
Check, if the lamp is screwed in firmly
In case of damage:
WARNING! Danger of electric shock and
fire through short-circuit. The device should
be repaired by an electrician immediately
X
10.2
Cleaning
WARNING
Danger of cutting and splitting through breaking or bursting lamp
Don´t let the lamps fall down.
Don´t touch the lamp with bare hands. Just touch the lamp at the plastic
socket or wear clean cotton gloves or use a clean cloth.
WARNING
Danger of electric shock
−
The contact with moisture or water should be avoided.
−
Unplug the power cord before cleaning the device.
ADVICE: Only use the following specified cleaning supplies.