WalimeXPro dalight 250 Instruction Manual - Warning
11
6.3 Screw in and out of lamp
WARNING
Danger of cutting and splitting through breaking or bursting lamp
Don´t let the lamp fall down.
Don´t touch the lamps with bare hands. Just touch the lamp at the plastic
socket or wear clean cotton gloves or use a clean cloth.
ADVICE:
Possible discolouration through burn marks on the lamps.
1.
Switch off device.
See
Switch on and off of the device
.
2.
Disconnect from power supply:
Plug out power cord.
3.
Let the device cool down.
CAUTION!
Danger of burning on lamps. Let the device cool down for
approx. 10 minutes.
4.
Screw in lamp:
Screw in the lamp carefully.
WARNING!
Danger of electric shock. Always screw in the lamp as to
avoid touching in the socket, when the device is switched on.
5.
Screw out lamp:
Screw out the lamp carefully and store it securely.
6.4
Connect to power supply
1.
Switch off device.
See
Switch on and off of device
.
2.
Compare the local power supply with the connected load of the device.
See
Technical specifications
.
If the values differ, please contact
info@foto-walser.de
or tel. +49 84 32
/ 9489-0.
3.
Connect the power cord with the socket on the device and with the
power socket.