Walker Bay 310H Assembly Instruction Manual - page 2
of
8
CM
Very Important!
NOTE:
Before you begin the installation process, make sure your boat hull is completely
stabilized. The boat should not be able to move freely in any direction.
TOOLS AND EQUIPMENT:
A 7/16” Nut Driver to remove seat bolts. One was supplied with your boat and its
assembly instructions.
Liquid soap and water for RID tube installation.
Step 1: Remove the
gunwale screws and the
gunwale caps from the
sides and bow of the
boat.
Step 2: Insert track into gunwale with the
capped end facing the stern of the boat.
Step 3: Reinsert gunwale cap into the gunwale
with the track firmly against the hull of the boat.
!
RID TRACK ASSEMBLY INSTRUCTIONS