Walker WP645TS-HD Operating Instructions Manual - Getting Started
First Time Installation - continued
11
Getting Started
the motor type. When fi nished, press OK to scan
for services.
• After setting antenna settings, press OK to
continue.
The box starts to scan services. The process of
scanning will take a few minutes. You can follow
the scanning process from the scroll bar. After the
scanning, fi rst time installation will be completed for
the satellite search. Scan results will be displayed
on the screen for the satellite channels.
Terrestrial Scan :
The box will be started to scan terrestrial channels
if search type is selected as Terrestrial scan.
After the scanning, fi rst time installation will be
completed for the terrestrial search.
Scan results will be displayed on the screen for
the terrestrial channels.
Scan results view:
Changing Channels
• You can change channels with the following
methods.
• You can press the numeric buttons (0–9) to directly
enter the channel number. You can press numeric
buttons consecutively to enter two or more digits.
• Press the P +/ P - buttons to move up or down to
the next available channel.
NOTE: You can press OK button to display the channel
list.
Volume Up / Down
• You can increase or decrease the volume by using
V+ / V- buttons.
• The volume level selected will remain set, even
when the receiver is turned off and on again, until
you change volume again.
• The audio volume adjustment for the receiver is
independent of the volume control on your TV
set.
IMPORTANT: You should be careful that both
volume controls are kept within reasonable levels
so that when switching on, or when fi rst turning on
your TV set, the sound level is not too high.
Mute
• You can press
to mute the sound of your set top box.
The sound will be muted once this button is pressed.
• To cancel mute, you can press
button again or
use the V +/- buttons.
01_TS7100_[GB]_DVB645_PVR_2712UK_10078521_50216711.indd Ksm1:11
05.04.2012 17:02:07