Walkera Master cp User Handbook Manual - page 12
06
Setup of the
RX2637H-D
receiver
6.3 Channel connection of receiver
AILE
ELEV
PIT
ELEV
The white wire is facing front.
AILE
The white wire is facing front.
PIT
The white wire is facing front.
Not used
Not used.
THRO
Connects to the main motor signal wire of ESC.
The white wire is facing front.
Not used
Not used.
POWER CHECK
Connects to Power check signal wire of ESC.
The red wire is facing front.
SPARE
After receiver upgrade to the programe with
telemetry function, connect to the temperature
sensor.
9
TAIL MOT
Connects to tail motor
signal wire
of ESC.
The Orange wire is facing front.
6.4 Testing Mode setting
Note: When mounting the receiver, please make sure the receiver is placed flat and perpendicular to
the main axis of the helicopter main rotor.
(1) Standard Transmitter: DEVO-7E
After code pairing successfully, Switch HOLD to position 1 and make sure the gyro setting position 1 Value
*
50.0%. Meanwhile the LED indicator starts to flash slowly, it enters into testing mode. You can adjust the
swashplate to horizontal level by adjusting the servos or mechanism or PIT adjustment. Switch HOLD to position
0 to enter flight mode after the adjustment finished. Flight is prohibited under testing mode.
HOLD SW
MIX SW
(2) DEVO-6/7/8S/10/12S Transmitter selectable
After code pairing successfully, Switch MIX to position 2 and make sure the gyro setting position 2 Value
*
50.0%. Meanwhile the LED indicator starts to flash slowly, it enters into testing mode. You can adjust the
swashplate to horizontal level by adjusting the servos or mechanism or PIT adjustment. Switch MIX to position 0
to enter flight mode after the adjustment finished. Flight is prohibited under testing mode.
9