WALLNER OS158Di Instruction Manual - Problem Solving
12
EN
PrOBLEM sOLViNG
problems
checklists
solutions
No operation
Is the power plug properly
inserted to main power supply?
Fully put the power plug to the
outlet.
Is the switch set to „ON” position? set switch to „ON” position for
operation.
Is the switch at „ON” position, but
power light is off?
check if basket is out of stand.
Put basket back on stand.
Is the basket on the stand, but
power light is off?
Basket should be put on the
stand to trigger the safety
interlock switch for operation.
No operation when you insert the
paper?
Paper should be inserted to
trigger the sensor in the centre.
You checked the above, but no
operation and no power light?
send back to your local service
for repair.
No operation after
long time operation
Power lamp is on?
Unplug the machine from
main supply. Allow it to cool
down to room temperature
and resume operation.
stop at shredding
Machine is continuously
shredding for a long time?
Unplug the machine from
main supply. Allow it to cool
down to room temperature
and resume operation.
excess squeaking
and rubbing noise
Without oiling of the cutting
system periodically, squeaking
and rubbing noise will increase
while shredding.
Perform the cutter oiling
instruction to lubricate the
cutting system.
Paper jam
- Did you exceed the shredding
capacity
- Is the paper fed squarely into
the feed opening.
set switch to „reV” for reverse
running and free excess paper.
Then set to „ON” for cutting the
remaining paper in the cutting
system. If serious jam occurred,
send back to local service for
repair.
© ArGO s.A.
www.argo.pl