WallyFlex WallyFlex Owner's Manual - Installation
installation
Note: For more information about the installation of the WallyFlex, contact your local authorized dealer.
The installation of the WallyFlex is done in two simple steps:
step 1
Plan the location and the installation of piping and low voltage wire for the WallyFlex.
Parts required (not included):
r "TSFRVJSFEàUUJOHTQJQJOHBOEMPXWPMUBHFXJSFGPSDFOUSBMWBDVVNTZTUFNT
r 1MBTUJDNPVOUJOHQMBUFHFOFSBMMZVTFEGPSUIFJOTUBMMBUJPOPGWBDVVNJOMFUT
1. Carefully choose the location for the installation of the WallyFlex, in order to
FOTVSFBOFBTZBOEFGàDJFOUVTFBWPJEPCTUBDMFTEFQFOEJOHPOUIFDMFBOJOH
tasks anticipated.
Note: Make sure that the chosen location is fully accessible for the installation of pipes
and low voltage wire (to the central vacuum unit).
2. The WallyFlex can be installed on a wall, or concealed in a closet or cabinet.We
recommend that you install the WallyFlex console approximately at 48 inches
(1.22 meters) from the floor.
3. Install the piping and low voltage wiring according to manufacturer’s
recommendations.
Note: Mounting plate must be installed level.
step 2
Install the WallyFlex on the mounting plate (see illustrations).
1. Turn OFF the central vacuum system.
2. Align and insert the extension on the back of the console into the inlet
PSJàDFPOUIFNPVOUJOHQMBUF
Fix the WallyFlex mounting plate with
the provided screws. Please note that
JGBFMCPXJTàYFEEJSFDUMZCFIJOE
the inlet mounting plate and installed
either up or down, you must use a #
10 1”¼ and a #10 1”½ screws rather
than two 1”½ screws. In order to avoid
QJFSDJOHUIFàUUJOHVTFUIFTIPSUFS
screw for the hole opposite the elbow.
3
OR
screw