WANDERS KANDA Users Manual & Installation - page 19

19

GB

Your Kanda stove at a single glance

The Kanda

The Kanda is a combination of comfort and efficient heat 

emission. The large glass panes allow emission of the 

heat from the stove directly to the environment to make 

your room instantly comfortable. The built-in flue gas 

deflector ensures circulation of flue gases in the interior 

parts. Combined with the extra after-burning, it means 

that the flue gases have better combustion and reduce 

the burden on the environment. 

The Kanda is equipped with 2 connections for the 

convection system. The supply of combustion air can be 

adjusted by handling the air grates.

The ash pan must be cleaned regularly to prevent 

damage.

Installation

It is common practice for the dealer where you purchased 

your Kanda stove to also take care of installing it. If this 

is not the case, please ensure that the installation is done 

by a certified installer. A certified installer can also give 

you the right advice about the flue tube to which the stove 

must be connected. Connecting wood-burning stoves 

by unqualified persons is prohibited, in which case we 

cannot give any guarantee about proper functioning of 

your Kanda stove. Please bear the fire safety in mind 

when installing the stove. See also page 22.

The wood-burning stove is suitable as an extra heat 

Usage early in autumn or late in winter

When the external and internal temperatures do 

not differ much, a proper chimney draught is a real 

challenge. You can help chimney draught get started 

by burning some wood while keeping all air inlets 

maximally open. An abundant air supply speeds up 

quick heating which in turn increases the draught 

in the chimney. Lighting up the stove with only a 

little wood prevents smoke from streaming into the 

room.

source and does not replace your principal heating 

device. 

Lighting the stove

The stove will become very hot when you light it and 

will need at least two hours to cool off. Don’t touch the 

stove without protection during firing and for two hours 

after. Handle the stove always with a glove to avoid 

getting serious burns.

Open the door and put some balls of paper or firelighters 

in the stove and place some wood kindling or brown 

coal briquettes on top. Light the kindling or briquettes 

and leave the door ajar for extra air supply. You can close 

the door after a couple of minutes. Do not place more 

than three logs in the stove at a time. Be sure that there is 

always enough ventilation when the stove is burning.

Open the door