WANDERS KANDA Users Manual & Installation - page 23

23

GB

Installation Instructions for the Kanda

General 

instructions 

  23

Preparation

  23

Installation

  24

Repairs

  27

Technical details Kanda

28

General instructions

The Kanda is tested in accordance with international 

EN13229 standardization. This hearth can be connected 

to a chimney to which several stoves are connected. The 

duct for the chimney has a diameter of 200 mm. The 

connection to the convection system has a diameter of 

150 mm.

The heating device must be placed by an acknowledged 

installer and according to the installation instructions 

given below. The national and local rules and regulations 

for placing and using wood-burning stoves are equally 

applicable. WANDERS does not give any guarantee 

if the Kanda is connected or installed incompletely or 

incorrectly.

It is not allowed to place the stove in:

• Arcades and corridors accessible to the public.

• Stairwells, except in buildings with no more than 2

dwellings.

• Spaces where highly flammable or explosive materials 

are used.

• Spaces where an exhaust system is used or where a 

mechanical exhaust system is placed, except when 

the air supply is taken directly from outside to assure 

a hazardless combustion.

Preparation

The chimney flue

Before placing the stove you must observe the following 

points:

• If the stove is connected to an existing chimney, you 

must first have the chimney professionally cleaned 

and checked by a qualified chimney sweep company. 

Any cut-off valves or stop valves must be removed. 

• The flue tube of the stove must be connected with the 

chimney without diversions.

• The underpressure in the chimney must be at least 12

Pa or 0.12 mbar.

• The chimney flue must always end up in outlet area 1

(see the drawing and the table below)

Roof slope x larger than 23° 

Roof slope x smaller than 23°