WANDERS SYMAX User Instructions - page 5

5

user instructions

WAN_SYMAX_EN_v.1.1_112016

Modes of operation

1  2

ON

AM

PM

OFF

M

  Thermostatic mode

The room temperature is measured 

and compared to the set temperature. 

The fl ame height is the automatically 

adjusted to achieve the set temperature.

ON

AM

PM

OFF

K

  Program mode

Programs 1 and 2. Each program can be 

programmed to go on and off  at specifi c 

times at a set temperature.

AM

N

  Ecowave mode

The fl ame height modulates between 

high and low. If the room temperature 

is lower than the set temperature, the 

fl ame height stays on high for a longer 

period of time. If the room temperature 

is higher than the set temperature, the 

fl ame height stays on low for a longer 

period of time. One cycle lasts approx. 

20 minutes.

Thermostatic mode

ON:

Press the E button. The M symbol is 

displayed, the preset temperature is 

displayed briefly and then the room 

temperature is displayed.

OFF:

1.  Press the E button.

2.  Press the A or B buttons to enter the 

manual mode.

3.  Press the F button to enter the 

program mode.

4.  Press the H button to enter the eco 

mode.

SETTING:

1.  Press the E button and hold until the 

M

 symbol appears. The temperature 

flashes.

2.  To adjust the set temperature press 

the A or B buttons.

3.  To confirm press the E button or wait.

ON

AM

PM

OFF

ON

AM

PM

OFF

Program mode

ON

AM

PM

OFF

ON:

Press the F button. K, 1 or 2, ON or 

OFF will be displayed.

1  2

ON

AM

PM

OFF

OFF:

1.  Press F or A or B to enter the Manual 

mode.

2.  Press the E button to enter the 

Thermostatic mode.

3.  Press the H button to enter the 

Ecowave mode.

NOTE:

The set temperature for Thermostatic mode is the temperature for 

the on time in Program mode. Changing the Rhermostatic mode set 

temperature also changes the on time temperature in Program mode.

Default settings:

ON TIME (Thermostatic): 21°C (70°F)

OFF TIME TEMPERATURE: "--" (pilot flame only)

ON

AM

PM

OFF

TEMPERATURE SETTING:

1.  Press the F button and hold until K 

fl ashes. ON and the set temperature 

is displayed (setting thermostatic 

mode).

2.  To continue press F or wait. K, OFF 

is displayed. Temperature fl ashes

3.  Select the off 

 temperature by 

pressing A or B .

4.  Press the F button to confi rm.

NOTE:

The on (thermostatic) and off  set temperatures are the same for 

each day.

ON

AM

PM

OFF

DAY SETTING:

5.   ALL fl ashes. Press A or B to choose 

between ALL, SAÚSU, ¡, ™, £, ¢, ∞, §, ¶.

6.  Press the F button to confi rm.