WangYe WY50QT-10 User Manual - page 16
- 27 -
Changing Oil from Gear box(Fig25)
Proposal Oil Trademark
SAE 80W/90(Using prevent frostbite Oil in the Very cooled area)
Oil capacity
Resolving capacity
:0.10L
Changing capacity
:0.09L
Place the vehicle by the main stand.
•
Screw out the leaking bolt 1 and oil-drain bolt 2.
Warning : When leak, the engine need a certain
temperature, the motor use main stand. Make sure all of
the oil is leaked.
•
Clean the drain bolt and then re-install it.
•
Inject the oil into hole of the leak bolt 1 till the oil spill.
•
Fix the leaking bolt 1 and screw it tight.
Fig25
2
1
- 28 -
Spark plug
(
Fig
26)
Spark plug specification
Standard:
C7HSA(NGK)or A7T、A7RT
•
Disconnect the joint of the spark plug cover and take
apart the spark plugwith special tool.
•
Check if any accumulated carbon or dirt, clean them
in cleanser or brusher. Replace the spark plug if badly
corroded.
Clean the carbon accumulates and dirt
thoroughly by spark plug cleanser or brush.
•
Normally the gap between side electrode (1) and
Center electrode (2) is 0.6-0.7 mm
•
Don’t use other spark plug without approval.
Fuse replacement
The rated electric current of the fuse is 15 A. If the fuse often burns down, it
indicates the short circuit or overload in the electric system. Ask the serviceman
to repair it, and never use the brass wires to replace the fuse.
(0.6~0.7)mm
1
2
Fig26