WANHAO Duplicator I3V2 Instruction Manual - 8. Finishing Techniques

Finishing

8. Finishing Techniques

8.1 Useful Tools/Equipment

•      Safety Goggles

•      Mask

•      Long-nose Pliers

•      Wire cutters

•      Sandpaper (100,200,300,400,500,600 Grit)

•      Medium, fine and extra fine sanding sponges

•      Acrylic based primer spray paint

•      Acrylic based spray paint (colour of your choice)

•      Acrylic based varnish spray paint

NOTE: 

Different paint types are also compatible with PLA and ABS. Consult your local paint supplier 

for the best compatibility for your intended purpose.

8.2 Removing Support Material

Even after support material is removed by hand, residual material will remain.

1. 

     Ensure that safety goggles and a mask are worn for protection

2.

      Remove most of the support material by hand, taking care not to

         damage the 3D object

3.  

    Using the long-nose pliers, carefully grasp some of the remaining

         material, then twist to remove. Repeat until no more material can be

         removed.

4. 

     Using the wire cutters, cut away any excess filament.

AFTER SALES SUPPORT

86-571-23290996

support@wanhao3dprinter.com

Model : Duplicator I3 V2

50