Wap SC 702 Operating Instructions Manual - page 9
9
EL heating oil or
diesel oil DIN 51 603
2.2 Before initial start-up
2.2.1 Machine
Secure machine with
locking brake.
Check oil level of high-
pressure pump
Cut off pin on oil plug.
Fill cleaning-agent tank
with pre-diluted Wap
cleaning agent.
Fill fuel tank with fuel (EL heating oil or diesel oil DIN 51
603) with machine cold. The fuel must be free of
impurities. The tank capacity is 11.5 l. CAUTION!
Incorrect fuels may not be used, as they may present a
hazard. If the tank runs dry, the fuel pump will be
destroyed.
At temperatures below 8 °C, the heating oil begins to
solidify (paraffin precipitation). This may result in burner
starting difficulties. Add solidification-point and flow
improver (available from heating-oil trade) to the heating
oil in due time or use diesel oil.
Fill reservoir for Wap automatic calcification alarm.
„Wap AntiKalk“ prevents lime deposits and acts as
corrosion protection at the same time. To fill, please use
the original-equipment bottle provided with the machine.
Then order the jumbo pack (6 x 1,000 ml - No. 8466) well
before the reservoir runs dry.
The anti-calcification concentrate must not impair the
deemulsifying property of the cleaning and care agent
used. Therefore, use only tested „Wap AntiKalk“.
Screw spray lance onto
spray gun and connect
high-pressure hose to
machine.
2.2.2 Water connection
Connect machine to water tap with 1/2" or 3/4" water
hose and open water tap.
The water supply tank fills with water.
Use only filtered water. Dirt particles contained in water
may damage the machine and the object to be cleaned.