WarbirdKits IAR-80 Assembly Manual - page 7
Assembly Manual for IAR-80 (Version 1.3)
Copyright 2012 Thomas A. Jacoby and WarbirdKits.com
7
Apply a light coat of primer – just enough to fill the
weave of the glass – and sand most of it off.
Paint and decorate the model as desired – see the
Paint and Markings Guide on our Website for more
information.
Glue the canopy in place.
Seal the entire model with a light coat of Krylon Crystal
Clear varnish.
Flying Setup
Keep the model as light as possible for best
performance.
The IAR-80A should balance at 1.5” behind the leading
edge at the center chord. This is approximately 24% of
the mean aerodynamic chord (MAC). For the first few
flights, you may want to move the balance point
forward 1/4”.
Set the control throws to:
Elevator: 1/2” up – 1/2” down
Ailerons: 3/8” up – 1/4” down
HELP!
If you have questions or need help with assembly of the kit,
drop an email to
tom@warbirdkits.com
.