Waring TAILGATER TG15 User Manual

Other manuals for TAILGATER TG15: Manual, Instructions
Manual is about: PROFESSIONAL FOOD AND BEVERAGE BLENDER SERIES

Summary of TAILGATER TG15

  • Page 1

    Tailgater ™ blender tg15 for your safety and continued enjoyment of this product, always read the instruction book carefully before using..

  • Page 2: Contents

    Contents important safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Important hot blending instructions . . . . . . . . . . . . . . . . . . 3 operating instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 how to assemble containers with removable blades . . . ...

  • Page 3: Save These Instructions

    2 7. Do not let cord hang over edge of table or counter, or touch hot surfaces. 8. Keep hands and utensils out of jar while blending, to prevent the possibility of severe personal injury and/or damage to the blender. A rubber spatula may be used, but must be used only when the blender is not running...

  • Page 4: Important:

    3 important: hot blending instructions to minimize possibility of being scalded when blending hot ingredients, the following precautions and procedures must be observed: . Begin blending with no more than one cup (8 oz.) of ingredients. 2. Before turning blender on, remove the center lid insert. Thi...

  • Page 5: Removable Blades

    4 how to assemble containers with removable blades always wash and rinse container prior to initial use. . Before starting, make sure that the blender cord is unplugged and that the switch is in the off position. 2. Refer to figure on page 5. The following points are important to note when putting t...

  • Page 6: Containers With

    5 how to disassemble and clean containers with removable blades always wash and rinse container immediately after use. . Be sure the switch is in the off position. 2. Remove the container assembly from the unit base and empty the contents. 3. To disassemble the waring pro ® tailgater ™ blender, turn...

  • Page 7: How To Clean Unit Base

    6 how to clean unit base . To clean the unit base, unplug the power cord. Wipe the exterior surfaces with a soft cloth or sponge dampened with cleaning solution. Rinse with clean water. Do not immerse the base in cleaning solution or water. Wipe the base with dry towel. Fuse replacement the plug on ...

  • Page 8

    ©2008 waring consumer products division of conair corporation 50 milford road east windsor, nj 08520 www.Waringproducts.Com printed in usa tg5 tailgater ib 08wr204 028340