WarmFlow B-Series B120 Owner's Manual - page 62

Page 60

12.0 OptionalBoilerMountedDigitalTimer

12.1 OperatingInstructions

12.1.1 AfterInstallation

When you first install the Cr2032 battery (by removing the clear plastic strip from the 

rear of the timer) you must press the ‘RESET’ button, the LCD display will display 

fully  for  3  seconds.  Then  LCD  display  will  change  to  ‘5:2d’.  You  can  press  DAY 

button to select ‘7d’, ‘24H’ programme mode.

This configures the timer as follows:

5/2d: 

5  day/2  day  programme  option  allows  different  ON/OFF  times  on 

weekday and weekend.

7d: 

7  day  programme  option  allows  different  programme  setting  on  each 

day of weekday and weekend.

24H: 

24 hours programme option runs same programme every day.

When you finalise the setting, press the CLOCK button for normal operation.