Warner RF FMT-150A User Manual - page 4
FMT-XXX (Ver. 2.1) User Manual
----------------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------
3
(Fig. 4)
3.
The transmitter goes into the options to select that if the RF power would be turned on. If not, the
transmitter works with 1 watt output. If yes, you can confirm this or leave it default, the transmitter
will go to next step.
4. The transmitter will automatically be in standby status after 6 seconds.
It displays working frequency,
volume, FETMOS operating temperature, output forward power, output reflected power and SWR.
图二
(Fig. 5)
You should know:
l
Output power will be adjusted upward from zero and can be reached to preset maximizing power
after 30 seconds.
l
In the SWR or temperature protection, output power will be dropped below 1 watt and alarm
message will be displayed. Output power will be automatically adjusted to the preset after
troubleshooting.
l
The display will turn off the backlight automatically if inactivated after 10 seconds, it can be lighted
up again when turning the adjustable knob.
MENU CONFIGURATION
In the standby status, press briefly the adjusting knob, enter into the first menu option as
frequency
set,
you can switch to other menu options by turning the adjusting knob left or right. All configuration
menu options are as follows,
1.
frequency set
2.
Audio Volume
3.
RF power Set
4.
Stereo or Mono
5.
Temp Set
6.
SWR set
7.
Mute
8.
Exit
The following is the detailed instructions of how to configure each menu option.
1. Frequency Set
(1) Press the adjusting knob to enter into frequency configuration menu.