WARPP INTIG 316 AC/DC Operator's Manual - page 4
INTIG 316/501 AC/DC
- 3 -
6
Power: (For electrically powered welding and cutting equipment) Turn off input power
before installation, maintenances and repair, so that avoid accident.
Huanyuan welding equipment is Ι class safeguard equipment; please install the
equipment by manufacture’s professional person
Ground the equipment perfectly in accordance with the manufacturer’s recommendations.
7
Power:(For engine driven welding and cutting equipment)
Work in ventilated place or outdoors.
Do not add fuel near to fire or during engine starting or welding. When not working, add
fuel after engine is cooling down; otherwise, the evaporation of hot fuel would result in
dangers. Do not splash fuel out of the fuel tank, and do not start the engine until complete
evaporation of the outside fuel.
Make sure that all the safeguard equipment's, machine cover and devices are all in a good
condition. Be sure that arms, clothes and all the tools do not touch all the moving and
rotating components including V belt, gear and fan etc.
Sometimes having to dismantle some parts of the device during maintenance, but must
keep safety awareness strongly every time.
Do not put your hand close to fans and do not move the brake handle while operating.
Please remove the connection between the engine and the welding equipment to avoid sudden starting
during maintenances.
When engine is hot, it is forbidden to open the airtight cover of the radiator water tank to avoid hurt by the
hot vapor.
8
Electromagnetic: Welding current going though any area can generate electromagnetic,
as well as the welding equipment itself.
Electromagnetic would affect cardiac pacemaker, the cardiac pacemaker users should
consult one’s doctor first.
The effect of electromagnetic to one’s health is not confirmed, so it might have some negative effect to
one’s health.
Welders may use following method to reduce the hazardous of electromagnetic:
a. Bundle the cable connected to the work piece and the welding cable together.
b. Do not enwind partially or entirely your body with the cable.
c. Do not place yourself between the welding cable and the ground (work piece) cable, if the welding cable
is by your left side, then the ground cable should be by your left side too.
d. The Welding cable and the ground cable are as short as possible.
e. Do not work near to the welding power source.
9
Lift equipment: carton or wooden boxes package the welding machines supplied by
Warpp Engg. There is no lifting equipment in its wrapper. Users can move it to the
prospective area by a fork-lift truck, then open the box.
If their are rings, the machine can be transited using rings. While our Welding Machine
Manufacture reminds users, there is possible risk to damage the welding machine. It is
better to push the welding machine moving in use of its rollers unless special situations.
Be sure that the appurtenances are all removed off when lifting.
When lifting, make sure that there is no person below the welding machine, and remind
people passing by at any moment.
Do not move the hoist too fast.
10
Noise: our Welding Machine Manufacture reminds users: Noise beyond the limit (over
80 db) can cause injury to vision, heart and audition depending on oneself. Please
consult local medical institution. Use the equipment with doctor’s permission would
help to keeping healthy.