WARRIOR W0703F Instruction Manual - page 23
'%
&.
2. Rotate the saw blade so that the same tooth used
STEP 1 is in the rear position shown in
A
6. Tighten the two hex head bolts that were loos-
STEP 3.
.
7. Tilt the blade to 45° .Turn the saw blade by
Aligning the miter slots to the blade
The saw table was aligned at the factory so that
the miter gauge slots are parallel to the saw bl-
ade. However, check the alignment before initial
operation.
Warning: Discount the machine from the po-
ower source.
1. Place a combination square A shown in Figure
40. on the table with one edge of the square in
the miter gauge slot. Adjust the square so that
the ruler touches one of the teeth on the saw b-
lade at the forward position( ).
31 Lock the
square in this position.
in
Figure
Figure
32. Check this distance. Both the front and rear
measurements should be identical.
4. To adjust, loosen the two hex head bolts B shown
in Figure 34. that hold the rear trunnion to the saw
table.
5. Use a rubber mallet(or a regular hammer and a
block of wood) to tap the trunnion C until the saw
blade is in the center of the table insert slot, and
parallel to the miter gauge slot.
ened in
hand to ensure that it does not contact the tab-
le insert.
31.
Figure
32.
Figure
Figure 34.
'&
Measure distance from T-solt to front
position of Saw Blade
Measure distance from T-solt to rear
position of Saw Blade
Adjust of position reartrunnion
3. To adjust, loosen the four button cap screws on
the trunnion access panel showed in Figure 33.
Figure 33.
B
C
D
Remove the trunnion access panel