WARRIOR W0703F Instruction Manual - page 3
&
BV^cHeZX^[^XVi^dch/
7aVYZ>c[dgbVi^dc
Maximum Blade Diameter.......................................................................................................................... 10 in.
Riving Knife/Spreader Thickness.............................................................................................. 0.09 in. (2.3mm)
Required Blade Body Thickness............................................................................ 0.074-0.082 in. (1.9-2.1mm)
Required Blade Kerf Thickness.............................................................................. 0.114-0.122 in. (2.9-3.1mm)
Maximum Width Of Dado.......................................................................................................................... 3/4 in.
Blade Tilt....................................................................................................................................... Left 0-45 deg.
Arbor Size..................................................................................................................................................5/8 in.
Arbor Speed....................................................................................................................................... 4200 RPM
Arbor Bearings........................................................................................... Sealed and Permanently Lubricated
Rim Speed.......................................................................................................................................11,000 FPM
8jii^c\8VeVX^i^Zh
Maximum Depth Of Cut At 90 Degrees..................................................................................................3-1/8 in.
Maximum Depth Of Cut At 45 Degrees..................................................................................................2-1/4 in.
Maximum Rip To Right Of Blade-Standard................................................................................................ 36 in.
Maximum Rip To Right Of Blade-Optional................................................................................................. 36 in.
Maximum Rip To Left Of Blade.................................................................................................................. 12 in.
IVWaZ>c[dgbVi^dc
Floor To Table Height.......................................................................................................................... 35-3/8 in.
Table Size Width........................................................................................................................................ 20 in.
Table Size Depth........................................................................................................................................27 in.
Table Size Thickness............................................................................................................................. 1-1/2 in.
Table Size With Extension Wings Width.................................................................................................... 44 in.
Table Size With Extension Wings Depth.................................................................................................... 27 in.
Table Size With Extension Wings Thickness......................................................................................... 1-1/2 in.
Distance Front Of Table To Center Of Blade............................................................................................. 16 in.
Distance Front Of Table to Blade At Maximum Cut............................................................................. 11-1/8 in.
;ZcXZ>c[dgbVi^dc
Fence Size Length............................................................................................................................... 33-1/4 in.
Fence Size Width................................................................................................................................... 3-1/8 in.
Fence Size Height................................................................................................................................2-9/16 in.
Fence Rail Type......................................................................................................... Angle Iron/Square Tubing
Fence Rail Length...................................................................................................................................... 66 in.
Fence Rail Width.......................................................................................................................................... 2 in.
Fence Rail Height.........................................................................................................................................2 in.
B^iZg
Miter Gauge Slot Type...............................................................................................................................T-Slot
Miter Gauge Slot Size Width..................................................................................................................... 3/4 in.
Miter Gauge Slot Size Height.................................................................................................................... 3/8 in.
8dchigjXi^dc
Table Construction...................................................................................................Precision Ground Cast Iron
Wings Construction..................................................................................................Precision Ground Cast Iron
Trunnions Construction........................................................................................................................ Cast Iron
Base Construction.................................................................................................................. Pre-Formed Steel
Body Assembly Contruction....................................................................................................Pre-Formed Steel
Fence Assembly Construction...............................................................................Steel with HDPE Side Plates
Rails Construction...............................................................................................................................Angle Iron
Guard Construction.........................................................................................................Steel and Clear Plastic
INTRODUCTION