1. DL manuals
  2. Warwick
  3. Amplifier
  4. BC150
  5. Owner's Manual

Warwick BC150 Owner's Manual

Other manuals for BC150: Owner's Manual
Manual is about: BASS COMBO AMPLIFIERS

Summary of BC150

  • Page 1

    Warwick owner’s manual bass combos bc20 bc40 bc80 bc150 f a m i l y o w n e d ◊ s o l a r p o w e r e d ◊ s u s t a i n a b l y m a n u f a c t u r e d i n a g r e e n e n v i r o n m e n t.

  • Page 2: Warwick Bc Series Combos

    Languages english 5 technical specifications bc20 10 bc40 11 bc80 12 bc150 13 front panel controls bc20/bc40 15 bc80/bc150 16 rear panel controls bc20/bc40 17 bc80/bc150 18 warwick bc series combos owner’s manual index.

  • Page 3: English

    C o m b o english 5.

  • Page 4: Warwick Bc Series Combos

    C o m b o 6 warwick bc series combos owner’s manual a series of compact amplifiers for bass instruments like nothing you have seen or heard before. These full frequency, extended headroom, integrated combo amps could be used for virtually any amplified instrument but are specifically tuned to the un...

  • Page 5: Integrated Speaker Design

    Dynamic distortion limiter ™ distortion occurs when an amplifier works beyond its range, when the power supply cannot supply the power any more to take the amp higher. A common method to control distortion in amps is to use a limiter, a device that stops the signal going beyond a specific level. Aud...

  • Page 6: Safety

    C o m b o 8 safety caution: to reduce the risk of electrical shock, do not remove the cover as there are no user serviceable parts inside. Refer servicing to qualified personnel. This symbol, wherever it appears, alerts you to the presence of non- insulated dangerous voltage inside the enclosure - v...

  • Page 7: For Bc20, Bc40 And Bc80:

    C o m b o 19. Correct disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the eu. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainab...

  • Page 8: Bc20

    C o m b o 10 bc20 • combo amplifier for bass instruments • passive and active inputs • class-a preamp with low-z circuitry for minimum noise and maximum headroom • 20 watt power amp • 8” warwick wxc 8/8 bass driver • 2” warwick wtr 2/8 neodymium high-frequency driver • 3-way eq with controls for bas...

  • Page 9: Bc40

    11 c o m b o bc40 • combo amplifier for bass instruments • passive and active inputs • class-a preamp with low-z circuitry for minimum noise and maximum headroom • 40 watt power amp • 10” warwick wxc 10/8 bass driver • 2” warwick wtr 2/8 neodymium high-frequency driver • 3-way eq with controls for b...

  • Page 10: Bc80

    C o m b o 12 bc80 • combo amplifier for bass instruments • passive and active inputs • line out • send/return on front panel • class-a preamp with low-z circuitry for minimum noise and maximum headroom • 80 watt power amp • 12” warwick wxc 12/8 bass driver • 2” warwick wtr 2/8 neodymium highfrequenc...

  • Page 11: Bc150

    13 c o m b o bc150 • combo amplifier for bass instruments • passive and active inputs • line out • send/return on front panel • class-a preamp with low-z circuitry for minimum noise and maximum headroom • 150 watt power amp • 15” warwick wxc 15/8 bass driver • 4” warwick wtr 4/8 high-frequency drive...

  • Page 12: Getting Started

    C o m b o 14 getting started 1. Unpacking – carefully unpack unit from the carton box. 2. Connecting to power – set the power switch in off position, connect the supplied power cord to the amplifier and then connect the same cord into ac outlet of proper voltage. 3. Setting front panel controls – se...

  • Page 13: Front Panel Controls

    15 c o m b o front panel controls bc20 and bc40 active – input to plug in instrument using shielded guitar cable. This input is low sensitivity to suit the output from instruments with active electronics. Passive – input to plug in instrument using shielded guitar cable. This input is high sensitivi...

  • Page 14: Front Panel Controls

    C o m b o 16 front panel controls bc80 and bc150 active – input to plug in instrument using shielded guitar cable. This input is low sensitivity to suit the output from instruments with active electronics. Passive – input to plug in instrument using shielded guitar cable. This input is high sensitiv...

  • Page 15: Rear Panel Controls

    17 c o m b o rear panel controls mains in ac – figure-eight socket for connection to the mains power supply. Power – on/off switch for main power. For your safety, remember to connect power cord to the amplifier first, then to the ac outlet. After this is done, turn this switch on. It works backward...

  • Page 16: Rear Panel Controls

    C o m b o rear panel controls bc80 bc150 mains in ac – ac terminal with integrated fuse compartment for connection to the mains power supply. Power – on/off switch for main power. For your safety, remember to connect power cord to the amplifier first, then to the ac outlet. After this is done, turn ...

  • Page 17: Troubleshooting

    Troubleshooting when your unit seems not to work properly, take a few minutes to troubleshoot before calling service. You can save yourself time and money by doing it yourself, because the source of problem is often something quite simple. What is the problem? 1. There is no sound from the amp and l...

  • Page 18

    Version 08-2011 nové warwick bass forum najdete na webov˘ch stránkách: hyperlink "http://www.Warwick.De máte-li nûjaké technické dotazy, pi‰te na: support@warwick.De please see the new warwick bass forum on www.Warwick.De for support information please refer to support@warwick.De visite por favor el...