Warwick FRAMUS Owner's Manual - Front Control Panel
152
FRONT CONTROL PANEL
INPUT
Socket for the connection of a guitar
For each of the channels Clean, Crunch and Lead the following controls are separately available:
GAIN
Rotary control to set the input sensitivity
PRESENCE
Rotary control to set the level of high frequencies in the power amplifier
VOLUME
Rotary control to set the volume level (relation of channels among each other)
BASS
Rotary control to set the level of low frequencies in the preamp
MIDDLE
Rotary control to set the level of mid frequencies in the preamp
TREBLE
Rotary control to set the level of high frequencies in the preamp
The following controls affect all channels:
EFFECT MIX
When using the FX Loop on the rear panel the EFFECT MIX allows you to dial in the
desired amount of effected signal into your overall sound. Turning the control fully clock-
wise will result in a fully effected sound, i.e. no dry signal and turning the control fully
counter-clockwise will result in a fully dry sound. When no effects are connected please
turn it fully counter-clockwise.
DEEP
This Control sets the level of low frequencies in the power amplifier.
MASTER 1
Control to set overall volume level 1
MASTER 2
Control to set overall volume level 2
CLEAN BUTTON
Activates Clean Channel and deactivates the other channels (LED lights up green when
activated)
CRUNCH BUTTON
Activates Crunch Channel and deactivates the other channels (LED lights up green when
activated)
LEAD BUTTON
Activates Lead Channel and deactivates the other channels (LED lights up green when
activated)
MASTER 2 BUTTON
Activates the MASTER 2 control and simultaneously deactivates the MASTER 1 control
(LED lights up green)
STANDBY
Switches the power amplifier to Standby mode
POWER
Switches the device On and Off