Warwick FRAMUS Owner's Manual - Rear Control Panel
153
REAR CONTROL PANEL
MAINS IN
AC terminal with integrated fuse compartment for connection to the mains power supply
MIDI IN-/THRU-Jacks and STORE-Button belong to the integrated MIDI Interface and will
be explained separately.
FOOTSWITCHES
Sockets for the footswitches that are used to switch between the three channels and to
switch between the two output volumes (MASTER 1 and MASTER 2). These are both
stereo sockets and are prior to MIDI. Don't use latching switches, please use momentary
(unlatch) switches.
EFF. SEND & EFF. RETURN
Sockets to implement the effects loop. Connect the input of the effects device to the
SEND socket and its output to the RETURN socket. This is a parallel effects loop and the
Wet/Dry balance can be controlled using the EFFECT MIX rotary control on the front
panel (see above).
LINE OUT JACK
For connecting of other Power Amps (Signal behind output transformer i.e. MASTER,
DEEP & PRESENCE-Controls have influence on this output)
SPEAKER OUT
Socket for the connection of speaker cabinets. Two sockets are provided, both of them are
internally switched parallel.
IMPEDANCE
Selector switch used to match the impedance to the connected speakers. (see also under
'Powering Up').
MEASURE POINTS
for the power tube bias and trimpot to adjust the bias.
Adjusting range 25 to 30 mA, max. 35 mA
POWERING UP
1. Make sure that one (or more) loudspeaker cabinet(s) are connected to the SPEAKER OUT socket, that it (they) has (have)
an adequate power handling capability and is (are) suitable for guitar signals. Check that the impedance selector switch
on the device corresponds with the total load impedance of the connected speaker(s).
2. Make sure that the device is plugged in to the mains and that any external (effects) devices are correctly connected and
operation ready.
3. Turn the MASTER control all the way to the left
4. Connect your guitar to the INPUT of the amplifier using a screened cable.
5. Turn the device on using the POWER switch.
6. When the valve(tube) warm-up phase is complete, turn the STANDBY switch on (upwards).
7. Set the desired volume using the MASTER control.
8. To obtain the desired sound for each channel, select the channel and adjust the controls. (See further under the heading
"Example Settings").
To familiarize yourself first of all with the basic sound of the amplifier, set all the rotary controls to 12 o'clock.
4
1 x 4
cabinet
2 x 8
cabinets
8
1 x 8
cabinet
2 x 16
cabinets
16
1 x 16
cabinet