Cd 260 rack conveyor dishwasher operator manual.
Warning before installation and commissioning, you must read the safety instructions and warnings carefully and all the warning labels attached to the equipment. Important failure to comply (even partially) with the instructions given in this manual will invalidate the product warranty and relieves ...
Safety instructions warning equipment contains dangerous voltages and can be hazardous if installed or operated incorrectly. Non-compliance with warnings or failure to follow the instructions contained in this manual can result in loss of life, severe personal injury or serious damage to property. I...
Installation warning installer must be suitably qualified and ensure compliance with all local codes and standards including as/nzs 3500.1. Failure to comply even partially with installation instructions may void the warranty. Positioning unpack machine, check for damage and complete delivery. Insta...
Installation & maintenance checklist check ok / notes maintenance item delivery supplied complete no transit damage position level and stable on sound, waterproof, self draining floor benchwork secure with smooth rack path in and out water isolator valve fitted accessible, all fittings sound, no lea...
Check ok / notes maintenance item amps temp.C° elements wash 65 rinse 80 eco-rinse 70 when fitted drier 85 when fitted pumps pre-wash n/a when fitted wash n/a correct rotation rinse n/a eco-rinse n/a when fitted motors drive n/a drier fan n/a when fitted electrical safety test if required water wa...
Operation description of controls operating instructions start up fit drain upstands, wash pump filters, scrap trays and shut doors. Turn wall and machine power switches on. Power light glows red and machine fills automatically. When machine is full, filling automatically stops. Ready light glows am...
Performance hot water supply an adequate supply of water at the correct temperature and pressure is essential for effective operation of your machine. Refer installation information for detail. Water softening is recommended in hard water areas - especially for glasswashing. Pre-rinsing pre-scraping...
Maintenance regular cleaning 1. Remove upstand 1 to drain wash tank. Remove scrap trays 2 and wash pump inlet filter 3. Clean them with water and a brush to clear grids. 2. Remove lower wash arms 4 – lift to unhook and then withdraw. Remove upper wash arms 5 – push the catch 6 up and then withdraw. ...
Information supplied in this manual is copyright. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical without the express permission of the author / publisher..
