Wasp WPL606 Quick Start Manual
5. Adjust the label guide by sliding it along
its bar to meet the width of the label. Then
rotate the Label Guide counter-clockwise
and secure it to the Media Guide Bar.
6. Adjust the Gap Detector to overlap at
least one inch of the label by moving the
yellow Gap Detector Handle located under
the media and just in front of the media
guide bar.
7. Close the print head lift lever.
8. Close the front panel and printer cover.
6. Install Drivers
Turn the printer on and wait for the Power
and Online lights to turn green. Put the Driver
CD in your CD ROM drive. The driver install
program should run automatically but if it
does not, run PrnInst.exe on the root of the
CD.
Follow the prompts to install the drivers and
set up the WPL606 printer.
7. Calibrate
Turn the printer off.
Press and hold the Pause button while
turning the printer back on. When the LCD
reads “GAP/BLINE sensor calibrating….” you
can release the button.
The printer will detect the gap and advance
the labels.
8. Software
The printer is now ready to print labels.
Labels can be printed from Microsoft Word or
from any label printing software. Wasp has
created a full featured label printing software
program called Labeler that is optimized to
print labels with the WPL606 printer.
9. Documentation
Several documents are included on the CD.
The user’s guide for the printer includes more
detailed setup instructions a trouble shooting
guide and care and maintenance.
#
000000
WPL606
Thermal Printer
Quick Start
Guide
© 2004 Wasp Technologies
Gap / Black
Mark Detector
Gap
Detector
Handle
Label Guide