Wasp WPL608 Quick Start Manual
Media Sensor Calibration
This utility is used to calibrate the sensitivity of
the media sensor. The media sensor should be
calibrated whenever changing the label media
or after printer initialization. Please follow the
steps below to calibrate the media sensor.
Method 1:
1. Make sure the ribbon and label media are
installed properly as described above.
2. Press
the
button to enter the
main menu.
3.
Press
and
buttons to
select the "Setup" option and press
button to enter this option. And
enter the "Sensor"option.
4. When enter this option, the sensor type in
the right side of ">" icon is the current
sensor setting. Press the
and
to select the sensor type, and
press the
button to calibrate
the media sensor.
Method 2:
1. Make sure the ribbon and label media are
installed properly as described above.
2. Turn off the printer power.
3. Hold
down
the
button and
turn on the printer power.
4. Do not release the buttons until printer
LCD shows "Calibrating...".
Printer Initialization
Printer Initialization will restore printer settings
to defaults. Please follow the steps below to
initialize the printer.
Method 1:
1. Press
the
button to enter the
main menu.
2. Press
and
buttons to
select the "Service" option and press
button to enter this option.
3. And
press
and
buttons
to scroll the cursor to "Initialization"
option and press
button to
restore printer settings to defaults.
Method 2:
1. Turn off the printer power.
2. Press and hold
and
button at the same time then
turns on the printer’s power.
3. Do not release the buttons until printer
LCD shows "Initializing...".
Remove Used Ribbon
1. Break the ribbon between ribbon guide
plate and the ribbon rewind spindle.
2. Push the ribbon release button to release
the ribbon on the ribbon rewind spindle.
3. Then, slide off the ribbon from ribbon
rewind spindle.
© 2008 Wasp Technologies
Wasp 610/608
Quick Start Guide
Loading Ribbon
1. Lift open printer right side cover. Push the
print head release lever to open the print
head mechanism.
2. Install the ribbon onto the ribbon supply
spindle. Thread the ribbon through the ribbon
sensor slot and then through the open space
in between print head and platen.
Print head
release lever
Ribbon Supply
Spindle
Print head
Platen