Watec WAT-902H2 ULTIMATE Operation Manual - page 2
•
Design and specifications are subject to change without notice.
•
Watec is not responsible for any inconvenience or the attendant damages
to the video and monitoring recording equipment caused bymisuse, mis-
operation or improper wiring of our equipment.
•
If for any reason the WAT-902H
2/3
ULTIMATE does not work properly, or if you
have any questions regarding installation or operation, please contact the
distributor or dealer from which it was purchased.
1340Z17-Y2000002
11) Select any required back light area by ⑬BACK LIGHT to one of its 4
positions.
Area
Switch
1. Default
2. Center
3. Lower
4. Center - Lower
※
The switches are set to OFF(Default) upon shipment.
12) Set the shutter mode by ⑭ELECTRONIC SHUTTER ON/OFF SWITCH
When shutter mode is OFF, fix the shutter speed to EIA1/60, CCIR1/50.
When shutter mode is ON, select the shutter speed mode by ⑮AE MODE
CONTROL.
※
The switch is set to OFF upon shipment.
13) Select any required shutter speed by the ⑮AE MODE CONTROL to one of
its 10 positions.
No.
Mode
Shutter Speeds (Sec.)
EIA
CCIR
0
FL
1/100
1/120
1
ES
1/250
2
ES
1/500
3
ES
1/1000
4
ES
1/2000
5
ES
1/5000
6
ES
1/10000
7
ES
1/100000
8
EI: OFF
1/60-1/100000
1/50-1/100000
9
EI: FL
1/100-1/100000
1/120-1/100000
※
An intense light may leave a trail on the screen longitude. This smearing is
a natural phenomenon and is not due to equipment failure or fault.
※
The dial is set to 0(FL) upon shipment.
Options
To purchase these options, please contact the distributor or dealer from which
you purchased the WAT-902H
2/3
ULTIMATE.
Specifications
Contact information
Watec Co., Ltd.
Add.:
I
254-2 Nihonkoku, Daihoji, Tsuruoka- Shi,
Yamagata-Ken, 997-0017 Japan
TEL: +81-235-23-4400 FAX: +81-235-23-4409
E-mail: info-o@watec.co.jp
URL: http://www.watec.co.jp
C-mount Adaptor (30CMA-R)
This lens mount adaptor is used to
convert a CS-mount to a C-
mount.
Mini Stand (MS50)
A convenient stand for the
WAT-902H
2/3
ULTIMATE. With this
stand, the camera can be adjusted
to any desired angle.