Water Factory Systems CoolerMATE Owner's Manual

Summary of CoolerMATE

  • Page 1

    © 2001 cuno incorporated 98-9100 1101 owner's manual this manual is for the installation, operation, and maintenance of the water factory systems coolermate drinking water appliances.

  • Page 2: Table of Contents

    Table of contents i. Installation requirements ......................................................................................3 ii. Water supply requirements ..................................................................................3 iii. Installation procedure ..........................

  • Page 3

    I. Installation requirements coolermate ® filter systems can be used with any point-of-use or converted bottled water cooler. It connects to any potable cold water supply using 1/4" plastic tubing and a saddle tapping valve or other suitable connector. The cooler must have a float control mechanism,...

  • Page 4

    Mounting method #2 - mechanical fasteners, bolts, screws or studs. In some cases it may not be possible or desirable to use the tape mounting method. There are two mounting holes in the system bracket that provides a variety of options for bolting or hanging the coolermate on the cooler. In some cas...

  • Page 5: Coolermate

    Note: some state and local plumbing codes may prohibit the use of saddle-type valves and/or drain connections. The use of saddle-type valves are prohibited in: alaska, delaware, idaho, kentucky, massachusetts, michigan, minnesota, new hampshire, north dakota, ohio, oregon, and south dakota. Check yo...

  • Page 6: Coolermate

    Coolermate ® installation diagram models cmf-350 dws, cmr-350 dws note: some state and local plumbing codes may prohibit the use of saddle-type valves and/or drain connections. The use of saddle-type valves are prohibited in: alaska, delaware, idaho, kentucky, massachusetts, michigan, minnesota, new...

  • Page 7

    7 1 push in grey collet to release tubing. 2 tubing is secured in. Push tubing straight in as far as it will go. Grey collet tube o-ring 1 pull tubing straight out. 2 to attach tubing to release tubing this product is outfitted with user friendly ‘push in’ connectors. Proper use of the connectors is...

  • Page 8

    Cuno incorporated 400 research parkway meriden, ct 06450 usa toll free 1-800-733-1199 worldwide 1-203-237-5541 fax 1-203-238-8701 www.Waterfactorysystems.Com • www.Cuno.Com.