Water Right UltroWater Installation, Operation & Service Manual - page 5
5
SECTION III. PREPARATION
A. Major System Components
The following components comprise the R.O.
Drinking Water System. (Refer to Fig. 1, below
for general system layout.)
• An R.O. Manifold assembly.
• Housings and Housing O–rings.
• A Drinking Water Holding Tank.
• A Dispensing Faucet.
• A Feed Water Saddle Valve.
• A Drain Clamp.
• Plastic Tubing and tube connectors.
• A Reverse Osmosis Membrane sealed in a
plastic bag.
• A Sediment/Carbon Module, shrink wrapped.
• An Activated Carbon Module, shrink
wrapped.
• Water Quality Monitor*
• Water Quality Test Kit for systems without the
Water Quality Monitor
• An In–Line Activated Carbon Post Filter,
shrink wrapped.
• Other items necessary for installation may
include wood screws or machine screws and
nuts for mounting the manifold, or concrete
anchors for hanging on basement wall.
Additional tubing or tube connectors. Plastic
wire ties for organizing tubing.
TYPICAL ULTROWATER UNDER SINk INSTALLATION DIAGRAM
* The Water Quality Monitor may be necessary to conform to
state or local codes; check with the local plumbing authority.
Figure 1
Dispensing Faucet with air gap
Drain
clamp
Drain
(3/8" Black)
prODuct
(3/8" Blue)
Drain
(1/4" Black)
inlet
(1/4" red)
tanK
(3/8" Yellow)
DrinKing
water
hOlDing tanK
hOlDing tanK
shutOFF ValVe
(Open position)
FeeD water
saDDle ValVe
(cold water line Only)
lOcate Drain clamp
aBOVe "p" trap
4" min
actiVateD
carBOn
mODule
reVerse
OsmOsis
memBrane
hOusing
seDiment/
carBOn
mODule
1
3
8
9
10
(1/4" Yellow)
pOlYtuBe
tee
7
water qualitY mOnitOr
Faucet Base (OptiOnal)
2
water qualitY mOnitOr caBle (OptiOnal)
rO maniFOlD
5
in-line actiVateD
carBOn pOst Filter
6
cOVer
4
RED
BLACK
YELLOW
IN
DRAIN
OUT
DRAIN
RESTRICT
OR
See Page 11
Close-up of Manifold