Waterax STRIKER-2/3 Quick Manual

Other manuals for STRIKER-2/3: Owner's Manual

Summary of STRIKER-2/3

  • Page 1

    01/2015 1 striker-2/3 quick guide this quick guide shows the basic operation of the waterax striker-2/3 multi-stage high pressure pump. The waterax striker-2/3 pairs a waterax 2- stage or 3-stage pump end with a honda gx390 gasoline engine. For instructions regarding the engine, as well as for oil a...

  • Page 2: Parts Identification

    Striker-2/3 quick guide 2 01/2015 parts identification a. Pump intake (suction) b. Pump drain port (not shown) c. Priming valve d. Quick release pump clamp e. Discharge check valve* f. Pump discharge g. Hand primer* h. Ignition switch i. Recoil starter j. Fuel cap k. Throttle (not shown) l. Fuel val...

  • Page 3

    Striker-2/3 quick guide 01/2015 3 4. Prime the pump. Check that all drains, discharge valves, or any auxiliary valves are closed before priming the pump. Open the priming ball valve (located between the pump and the primer). Manual priming: if the unit is equipped with a hand primer, open the primin...

  • Page 4

    Striker-2/3 quick guide 4 01/2015 to shut down and store the striker-2/3 unit: 1. Shut down the pump. A. Gradually reduce the engine speed. B. Whenever the unit has been run at full throttle for most of the operation, allow the valves to remain slightly open and run the engine at idle for approximat...