WaterChef Countertop C7000 Installation, Use & Care Manual - Setup & Installation
www.waterchef.com
I
4
setUP & InstallatIon
10. Determine which side of the sink
you want your System:
to position system to the leFt side
of your sink: Unthread Lid Assembly
from Filter Housing, then orient the Lid
Assembly to Filter Housing as shown.
(fig. F, step 1)
Once positioned, thread
Lid Assembly clockwise onto the Filter
Housing until tightened.
(fig. F, step 2)
to position system to the rIGHt side
of your sink: Unthread Lid Assembly
from Filter Housing, then orient the Lid
Assembly to Filter Housing as shown.
(fig. G, step 1)
Once positioned, thread
Lid Assembly clockwise onto the Filter
Housing until tightened.
(fig. G, step 2)
11. Press the elbow fitting on Diverter Valve Assembly
into the Filter Base.
(fig. H)
12. Insert Battery Shuttle (with included Battery) into Lid
Assembly.
(fig. I)
The Intelligent Monitor
™
will flash
GREEN, YELLOW and RED five times and will then
start blinking GREEN. This resets the rated capacity
counter to zero gallons. Do not remove Battery Shuttle
until it is time to replace Cartridge. Removing Battery
Shuttle prematurely may result in a loss of data.
13. With System placed on the counter and positioned
so that water will flow into kitchen sink, turn the cold
water “ON” and pull the Diverter Pin. Water will begin
entering the Filter Housing. Check to see that all
hose, clamp and housing connections are tight and
do not leak.
(fig. J)
14.
allow system to flush into sink for 15 minutes.
This will remove any fine, black carbon particles left
over from the manufacturing process, expel trapped
air and condition the Cartridge for normal use.
(This water may be used to water plants.)
spout
facing
into sink
spout
facing
into sink
steP 1
steP 1
steP 2
steP 2
leFt Placement
rIGHt Placement
line up
Front
of Lid
Assembly
with hose
outlet
line up
BaCK
of Lid
Assembly
with hose
outlet
F
G
H
J
Repeat flushing procedure each time a new Cartridge is installed.
Important