WaterChef Countertop C7000 Installation, Use & Care Manual - Replacing The Cartridge
www.waterchef.com
spout
facing
into sink
spout
facing
into sink
steP 1
steP 1
steP 2
steP 2
leFt Placement
rIGHt Placement
line up
Front
of Lid
Assembly
with hose
outlet
line up
BaCK
of Lid
Assembly
with hose
outlet
6
5. Determine which side of the sink
you want your System:
to position system to the leFt side
of your sink: Unthread Lid Assembly
from Filter Housing, then orient the Lid
Assembly to Filter Housing as shown.
(fig. n, step 1)
Once positioned, thread
Lid Assembly clockwise onto the Filter
Housing until tightened.
(fig. n, step 2)
to position system to the rIGHt side
of your sink: Unthread Lid Assembly
from Filter Housing, then orient the Lid
Assembly to Filter Housing as shown.
(fig. o, step 1)
Once positioned, thread
Lid Assembly clockwise onto the Filter
Housing until tightened.
(fig. o, step 2)
6. A new Battery is included with your replacement
Cartridge. Insert new Battery into Battery Shuttle
and insert into Lid Assembly.
(fig. P)
The Intelligent
Monitor
™
will flash GREEN, YELLOW and RED five
times and will then start blinking GREEN. This resets
the rated capacity counter to zero gallons.
Do not
remove Battery shuttle until it is time to replace
the Cartridge again. removing Battery shuttle
prematurely may result in a loss of data.
7. Position the System so that water will flow into
kitchen sink. Turn the cold water faucet “ON” and
pull Diverter Pin. Water will begin filling the Filter
Housing.
(fig. Q)
8.
allow system to flush into sink for 15 minutes.
This removes any fine, black carbon particles left
over from the manufacturing process, expel trapped
air and condition the Cartridge for normal use.
(This water may be used to water plants.)
n
o
rePlaCInG tHe CartrIdGe
P
Q
Repeat flushing procedure each time a new Cartridge is installed.
Important